Comments on: Clone Microsoft Windows XP using Sysprep and Norton Ghost, Part III: Duplicate Disk with Norton Ghost

By: Sarah

Sarah — Mon, 07 Mar 2011 22:59:43 +0000

I am trying to use your technique, but Ghost 12 doesn’t seem to have a DOS disk to disk. When I boot to the Recovery CD I only have options to recover not backup. I did sysprep then I was forced into a reboot. Then I backed up the source computer using Ghost 12 to a USB drive. Tomorrow, I will try to recover a destination computer using this technique, but I am concerned because I have already had to do the mini-Setup.

By: taufik

taufik — Sat, 06 Mar 2010 04:53:51 +0000

and .. I wait the articles other than your good ..

By: taufik

taufik — Sat, 06 Mar 2010 04:51:55 +0000

well .. thank you very much.
forward always to your success …

By: linglom

linglom — Fri, 26 Feb 2010 03:16:55 +0000

Hi, Taufik I haven't done on Vista yet. There is an document on Microsoft's Technet, see Windows Vista Deployment Step-by-Step Guide

By: taufik

taufik — Thu, 25 Feb 2010 03:41:02 +0000

how about cloning for windows vista if you can send the manual to my email address? thanks for the help.

By: linglom

linglom — Wed, 03 Feb 2010 04:00:21 +0000

Hi, Arun
Have you run ghost in dos-mode? Normally, ghost can see sata drive.

By: tech123

tech123 — Sun, 31 Jan 2010 04:01:51 +0000

thxs

By: arun

arun — Thu, 28 Jan 2010 14:46:04 +0000

i am to using this nortonghost but i am facng problem i have doubt wheter it supports sata or not and whn i want to make a ghsot image of partion i am not able to it says ghosterr.txt could nto open

By: linglom

linglom — Wed, 04 Mar 2009 01:56:43 +0000

Hi, Wadhi
I’ve never tried on Vista yet. But it should works, Norton Ghost duplicates data in a lower level than OS.

By: wadhi

wadhi — Tue, 24 Feb 2009 16:48:51 +0000

thanks linglom…how bout windows vista..any idea